Heat Pump - No Cooling
- Check the settings on your thermostat. Make sure the temperature control selector is set below the current room temperature, and the system switch is on the COOL or AUTO position. The fan switch should be set to ON for continuous airflow or AUTO if you want the blower to operate only while the heat pump is operating.
- Try to get the heat pump to turn on by lowering the thermostat to its lowest temperature setting.
- If the air flow out of your registers seems low, check the air filter. An extremely dirty air filter can block air flow.
- Make sure all registers are open and not obstructed.
- Check the power disconnect switch by each unit (outdoor and indoor).
- Check the fuse/breaker at the electrical panel for both the outdoor and indoor unit.
- If the problem persists, please call us.
- Have you allowed your Electric Power Supplier to add a Peak Demand Kill Switch (Energy Saver) to your outdoor unit? If so, you might check to see if your neighbor's cooling is working as they tend to kill power by zones on Peak Demand Days. You may want to wait 1/2 hour to see if the power to your unit is restored.
